|
Post by damflask on May 25, 2020 6:24:27 GMT
Hello, I’m looking for a cover plate for a biscuit bridge resonator, preferably a steel one.
|
|
|
Post by bonzo on May 25, 2020 7:11:52 GMT
Hi damflask, just in case you may not be aware, coverplates have holes in different places. If they don't match up you'll have to drill new ones. Something to bear in mind. Good luck with your search.
Best wishes to you all, John
P.S. the holes would be drilled in the body, not the coverplate!
|
|
|
Post by damflask on May 25, 2020 7:33:42 GMT
Thanks! I don’t mind drilling holes if that’s what it takes
|
|
|
Post by pete1951 on May 25, 2020 17:56:35 GMT
I have a few spare cover plates, they also have various pressing heights. I will get them out tomorrow and have a look. I might have a steel one but most are nickel plated brass. Some are second hand but in good condition (£20+p/p) some new (£35+p/p) Pete The steel one is from an old MM Blues, so is steel with a paint finish (if I can find it) and will have MM pressed on the hand rest. What guitar is it going on?
|
|
|
Post by damflask on May 25, 2020 18:27:30 GMT
Hi, That's brilliant, thank you so much Pete ! It's actually going on an MM Blues that I have just purchased on the Bay of E, which I am planning to paint in Collegian Blue (long story) and I would much rather have one without the MM logo on the hand rest ( I will of course retain the logo on the headstock). I've looked everywhere online for one, so thanks very much for your response. Brass is fine!
|
|
|
Post by damflask on May 25, 2020 19:13:50 GMT
I have sent you a message pete1951
|
|